Installation Information

LOW-RIDER
The LOW RIDER has a unique feature that allows it to fit several different size transmission humps no matter which type of car you drive. Underneath the “LOW RIDER” are two aluminum coated plates that are curved to accommodate narrow transmission humps on some of the ’60s GM and Ford cars. These aluminum coated plates can be easily adjusted (bent) to conform to just about any automobile transmission hump. If not needed these Aluminum plates can easily be removed.

MODEL-A VAGABOND-L AND VAGABOND-S CONSOLE
Installation is fast and easy WITH NO PERMANENT alterations or tools needed. Simply unscrew the gear shift knob, slip the Shifter Boot over the shifter and slide down to the floor board—- reinstall the shifter knob and your ready to enjoy your new FORD model “A” console with drink holders.

63-66 CORVETTE BULLITT CONSOLE
Just slip over factory armrest and start cruising! Our Console is designed with TALL side to slide down snuggly over the transmission hump.

HUMPHUGGER CONSOLE INSTALLATION
The Humphugger has a Velcro bottom making installation fast and easy with NO tools needed OR permanent changes to your interior. Simple set the HumphuggerTM on the carpeted transmission hump and you’re ready to cruise!

SADDLE CONSOLE INSTALLATION
Installation is fast and simple. Just slide the saddle console over the factory console from the back seat forward to desired position.

HUMPHUGGER CRUISER CONSOLE
Rest on Transmission hump between bucket seats and fits over floor shifter( Shifter opening is 4″x6″) Brushed aluminum plate.

SADDLE CRUISER CONSOLE
Full length Console that fits over Factory console. Easy to install place saddle cruiser console over rear of factory console lower into place and fit shifter through shifter plate opening while lowering the console.

CORVAIR CONSOLE
Slide console from backseat forward between the bucket seats cupholders in front. Adjust to desired position.

BC-CRUISER AND BD-DRINKSTER BENCH SEAT CONSOLES
Install is fast and simple. Place console on bench seat. Using the nylon strap that comes out back of console Run it under bench seat to the front and attach it to the nylon strap with bucklet hat is attached to front of console.